Burn Speed

what speed should i use to burn a operating system
Answer #1
4X is recommended.
Answer #2
you should make it slow – less problems
Answer #3
you should make it slow - less problems
apparently not in my case
Answer #4
i burn at 32x usually no issues 8x if dvd
Answer #5
I always burn at max speed and have never run into any issues.
Answer #6
I always burn at max speed and have never run into any issues.
same here. it’s been a couple years since i had a bad burn.
Answer #7
apparently not in my case
what exactly is the problem then ?
Answer #8
Burn at the lowest speed possible for consistent quality burns. What’s the rush anyways?
Answer #9
Burn at the highest speed the software allow you…Those days of burning at low speed are gone…With modern burners it won’t make no difference if you burn at low or high speed…
Answer #10
Burn at a speed not too high nor too low. Something close to the lowest is the best and the chances of error are lower at lower speeds.
Answer #11
You should burn at half of the max manufactured stated.